Most of my work on this site is kitchen renovation, but I also take on residential bathroom renovations. The approach is the same. I check the existing condition, the substrate and the waterproofing before anything new goes on the walls or floor, and I prepare a written quotation once I’ve seen the room.
The same enquiry form covers bathroom work. Just mention your bathroom in the message.
Reference photo: a spirit level in use. In a bathroom, wall flatness and floor falls are checked before any tile layout is set out.
These are the same fields I use for an on-site kitchen assessment, adjusted for a wet area. An inspection can’t reveal every concealed issue, so the scope stays tied to what can actually be seen and tested.
AExisting condition
Cracked or drummy tiles, failing grout and silicone, staining on adjoining walls or skirting, and how the room is used day to day. This decides what can be kept and what needs to come out.
BWaterproofing and substrate
Signs of moisture, the condition of the wall linings and floor, and whether the surface is suitable for new tiles. If the existing membrane is in doubt, tiling over it only postpones the problem.
CTiling and finishing
Floor falls, wall flatness, tile layout and suitable materials for a wet area. More detail is in Bathroom Tiling.
DServices
Where the taps, waste, exhaust fan and power points sit now, and whether the plan moves any of them. Moving them means bringing in licensed trades.
WHY PREPARATION COMES FIRST
If you replace the visible finishes without first checking for moisture, substrate suitability, service access and underlying damage, you can end up redoing the work. In a bathroom the risk is higher because the finishes are in contact with water every day.
The right scope depends on the inspection. Waterproofing requirements, and who carries out each regulated part of the work, are confirmed for each project rather than assumed. The general principle is covered on Surface Preparation and Hidden Conditions.
MY PART
The assessment, practical options, surface preparation, tiling and finishing work within my scope, and organising the job. I’m an independent sole trader, and I don’t claim trade licences or builder registration that I can’t verify.
AUTHORISED SPECIALISTS
Licensed plumbing and electrical work is carried out by appropriately authorised specialists. Permits, registration, insurance and licensed trade requirements vary from project to project. More on Licensed Trades for Plumbing and Electrical.
Reference photo: finishing compound being applied to an interior wall. Wall linings are prepared in the same way in a bathroom, a laundry or behind a kitchen splashback.
Bathroom work relies on the same skills as a kitchen renovation in Malvern: reading the condition of walls and floors, preparing surfaces properly and choosing suitable materials. I have approximately 15 years’ personal experience in residential renovation, including bathrooms, laundries, tiling, flooring and plastering.
If your bathroom has loose tiles, failing grout or signs of moisture, or the layout simply no longer works for you, start with a conversation and a free on-site assessment. The written quotation follows the assessment, not before. Contract, insurance and approvals wording is verified for each project. There is no 24/7 emergency service.
Bathroom enquiries use the same form as kitchen enquiries. Tell me about the room in your message.