Home / Services / Plasterboard Installation and Plastering

Chapter 09 — Plasterboard & plastering

When the cabinets come off, the wall behind them becomes part of the job.

Taking out old wall cabinets or a tiled splashback rarely leaves a clean wall. You’ll usually find fixing holes, torn plaster paper, adhesive residue and old cut-outs. I’m Ivan Bodnar, an independent home renovation specialist. Plasterboard installation and plastering is a related capability alongside my main work, which is kitchen renovation in Malvern. Its job is to give new tiles and paint a sound, flat surface to sit on.

SPECIALISTS

Reference photo above: finishing compound applied with a trowel and hawk.

Field 9.1 — After removal

Patch it, cut out a section, or replace the sheet?

Which way to go depends on what’s left once the old joinery and tiles are off. I check how much damage there is, how firmly the board is still fixed and how flat the wall is.

Patch and set. Small fixing holes and minor tears can usually be filled, set and sanded back flush.

Cut out and replace a section. When tile adhesive has torn the board face, or old service openings no longer line up, the practical option is often to replace a section.

Replace full sheets. Widespread damage, a wall that’s badly out of flat, or a new layout that changes most of the wall can make new plasterboard the cleaner choice.

For how this ties in with new cabinetry, see Layout, Cabinetry and Practical Options.

A severely damaged kitchen with peeling ceiling and wall surfaces, debris covering the floor, and older wooden cabinets and counters.

Reference photo: broken wall and ceiling surfaces in an older kitchen. Damage like this gets assessed before anyone talks about patching.

Field 9.2 — Moisture

Find the source before replacing the board

Behind the sink, the dishwasher and the old splashback, plasterboard can turn soft, stained or swollen. Putting new board or paint over a wet area without dealing with the cause usually means doing the work twice. If a leaking pipe or fitting is the cause, a licensed plumber repairs it before the wall is rebuilt.

Once the area has dried and the cause is fixed, I discuss which replacement board suits that position. An inspection can’t reveal every concealed issue, so the scope may change once a wall is opened up. More on this in Surface Preparation and Hidden Conditions.

Field 9.3 — Finishes

Flat, dry and sound before the finish

01Sound and fixed. Loose board moves under tiles and leads to cracking, so it’s re-secured or replaced first.

02Flat enough for the finish. A splashback in large-format tiles needs a flatter wall than a painted surface does. I check with a straight edge before I talk about tiles.

03Joints set and sanded. Under paint, poorly finished joints and patches show up in side light, especially along a bench line.

04Prepared for the next trade. The surface is cleaned and primed or sealed to suit what goes on next: tiling and kitchen splashbacks or interior painting.

Field 9.4 — Specialists

Plastering is a surface job. Moving walls is not.

Removing, opening up or altering a wall, particularly one that may be load-bearing, needs the right specialists. That can include a structural engineer and, depending on scope, registered building practitioners and approvals. I don’t provide structural engineering or architectural design.

When power points or water lines move within a wall, appropriately authorised specialists do that work before the board goes back on. Board installation and finishing are then coordinated around them. See Licensed Trades for Plumbing and Electrical.

I’m an independent sole trader, and I don’t personally claim trade licences or builder registration. Permits, registration, insurance and licensed trade requirements vary from project to project, and contract and approvals wording is checked for each job.

Plastering is usually priced as part of a kitchen renovation rather than on its own. After an on-site assessment of the walls, cabinetry and services, I prepare a free written quotation that sets out what will be patched, replaced and prepared. If you’d like to know what’s behind your old splashback before you choose a new one, start with a short enquiry.