Home / Services / Tiling and Kitchen Splashbacks

Chapter 07 — Tiling & splashbacks

Can you replace the splashback? Yes, once the wall behind it has been checked.

A new splashback or a tiled kitchen floor is often part of a kitchen renovation in Malvern, and sometimes it’s the whole job. Either way, the tiles are the last layer. I’m Ivan Bodnar. Before I suggest a tile, I look at the plaster, the substrate and the moisture around the sink, because those decide how long the new surface will last.

7.1 — Behind the old tiles

What removing a splashback can reveal

Old tiles rarely come off cleanly. The plaster underneath often tells you more about the wall than the tiles ever did. An inspection can’t reveal every concealed issue, so the scope is confirmed once the condition is visible.

01Torn plaster face
Adhesive can pull the paper or surface coat away with each tile, so the wall needs repair before it’s flat and sound enough to tile again.

02Moisture near the sink
Softened or stained board behind the tap area is a sign water has been getting through. Covering it with new tiles only hides the problem.

03Uneven or patched wall
Earlier repairs, filled holes and bowed sections become obvious once the tiles are off. Large-format tiles in particular show every high spot.

04Power points and pipes
Outlets and pipe penetrations may need adjusting to suit the new tile thickness. That work goes to licensed trades, not to me.

7.2 — WALL PREPARATION

Prepare the wall first, then choose the tile.

Replacing visible finishes before checking moisture, substrate suitability, service access and underlying damage can cause avoidable rework. For a splashback, that means repairing or replacing damaged plasterboard, getting the wall flat enough for the tile size you’ve chosen, and dealing with any moisture source before anything is fixed to it.

The full reasoning is set out in Surface Preparation and Hidden Conditions, and board repairs are covered under Plasterboard Installation and Plastering.

An older wood-panelled kitchen with extensive cabinetry, dated appliances, a double sink, patterned flooring and a skylight.

Reference photo: an older kitchen with a patterned tiled floor running along the cabinet line. What to check before retiling: whether the floor is level and solid, and how the cabinets and kick boards meet it.

7.3 — Kitchen floors

Tiling a kitchen floor starts with the floor itself

“The floor is uneven” is a common starting point. Before tiling, I check whether the existing floor is level and solid, what it’s made of, and whether the cabinets will sit on the tiles or the tiles will run up to the cabinets. That order affects heights, kick boards and appliance clearances.

If the substrate isn’t suited to tiles, another floor finish may make more sense. Flooring and Uneven Floors and a New Kitchen cover those options.

7.4 — Materials

Choosing suitable materials

SPLASHBACK

Heat near the cooktop, splashes from the sink and how easily grout lines can be cleaned. Tile size has to suit how flat the wall can realistically be made. Trims and edges need to finish neatly against benchtops, overhead cabinets and window reveals.

FLOOR

Slip resistance in a room that gets wet, durability under foot traffic and dropped pans, and an adhesive and grout suited to the substrate. The finished height also has to work with doorways and adjoining floors.

Splashback and floor tiling are related capabilities alongside my main kitchen work. For wet areas, see Bathroom Tiling. For more detail on splashbacks, read Replacing a Kitchen Splashback: What to Consider. I’m an independent sole trader and don’t claim trade licences or builder registration. Licensed plumbing and electrical work is done by appropriately authorised specialists. Scope, permits and licensed trade requirements vary from project to project.

If you’d like your splashback or kitchen floor looked at, the first step is a free on-site assessment. You’ll get a written quotation after that.